Maintenance - SPARKY HeavyDuty BU2250 Instrucciones De Uso

ACCESSORIES TO BE USED WITH
THIS POWER TOOL
▪ Drill bits for metal Ø3 to Ø16 mm
▪ Drill bits for wood Ø3 to Ø40 mm
▪ Drill bits for concrete Ø3 to Ø25 mm
▪ Screwdriver bits with 6,35 mm (1/4") hexagon
shaft

Maintenance

WARNING: Always ensure that
the tool is switched off and unplugged
before attempting to perform inspection or
maintenance.
BRUSH REPLACEMENT
This power tool is equipped with auto-stop
brushes. When the carbon brushes are worn
out, the machine switches itself off. In this case
both brushes must be replaced simultaneously
with genuine brushes at SPARKY service centre
for warranty and post-warranty service.
GENERAL INSPECTION
Regularly inspect all fasteners and ensure they
are properly tightened. Should any of the screws
be loose, retighten it immediately to avoid haz-
ards.
If the replacement of the supply cord is neces-
sary, this has to be done by the manufacturer or
his agent in order to avoid a safety hazard.
CLEANING
For safe operation always keep the machine
and its ventilation slots clean.
Regularly check to see if any dust or foreign
matter has entered the ventilation slots and the
grills around the switches. Use a soft brush and/
or air jet to remove any accumulated dust. Wear
safety glasses to protect your eyes whilst clean-
ing.
Exterior plastic parts may be cleaned with a
damp cloth and mild detergent if necessary.
WARNING: Never use alcohol, petrol
or other cleaning agent. Never use caustic
agents to clean plastic parts.
Original instructions
WARNING: Water must never come
into contact with the tool.
IMPORTANT! To assure product safety and
reliability, repairs, maintenance and adjustment
(including brush inspection and replacement)
should be performed by certified service centres
or other qualified service organisations, always
using genuine replacement parts.
9
EN