Dremel 9050 Instrucciones De Funcionamiento Y Seguridad página 10

DM 2610033061 04-14_9050 11/18/14 8:40 AM Page 10
BUMP SWITCH (ON/OFF)
This tool is switched "ON" by the bump switch
located on the back of the motor housing
(Fig. 5).
TO TURN THE TOOL "ON" slide the switch
button up or "I" position.
TO TURN THE TOOL "OFF" slide the switch
button down or "0" position.
Hold the tool with both
WARNING
!
hands while starting, since
torque from the motor can cause the tool to
twist.
MAKE A FEW PRACTICE CUTS
After installing the bit into the tool and
adjusting your depth guide, you should make
a few practice cuts with the tool before
attempting an actual job. A few exercises will
give you the necessary practice to make
clean, professional cuts.
Step 1: Make certain that the collet nut is
securely tightened before turning the tool on.
Step 2: Hold the tool firmly and turn the tool
ON to your desired speed.
Step 3: While holding the tool firmly, insert the
bit into the material at a 45° angle (Fig. 6).
Step 4: Slowly bring it to a 90° angle to begin
the cut (Fig. 7). The base guide should be
flush to the material surface. For all materials
(EXCEPT cutting around outlet boxes in
drywall), steer the tool in a clockwise direction
with slow, steady pressure to make the cut.
Step 5: After completing your cut, turn off the
tool and carefully remove it from the material.
Do not attempt to use this tool to make cutouts
around any fixture or opening which has live
electrical wires, or any wall which may have
live electrical wiring behind it, as the bit could
conduct current to the tool, creating an
electrocution hazard for the operator. Shut off
breakers or remove fuses to disconnect the
circuit. Always hold the tool by its
thermoplastic housing, and always wear eye
protection when operating a rotary saw power
tool.
NOTE: Because of the rotating cutting action
of the bit, there will be a slight pull when
cutting. The slower you cut, the more control
you have. Excessive pressure or fast cutting
Operating Instructions
FIG. 5
will cause excessive heat and may shorten
the life of the bit.
NOTE: When cutting on a vertical surface,
avoid ending your cut at the bottom of the
hole. If possible, start and end your cut at the
top so the scrap part will not drop onto the
rotating bit. Turn the tool off and remove it
from the material.
-10-
DV-2610033061, Page: MUL (VAA), downloaded at: 2015.07.16_19:13:47, by PT-RT/MKP1_Carolina.Moreton
BUMP
SWITCH
(ON/OFF)
O
I
FIG. 6
FIG. 7