Flip-Back Armrests; Flip-Back Height Adjustable Armrests; Height-Adjustable Armrests; Caster Plates - Sunrise Medical Quickie LXI Manual De Instrucciones

E N G L I S H
I. FLIP-BACK ARMRESTS
Flip-back armrests are shipped standard on Quickie LXI wheelchairs. They are installed by
Sunrise.
To flip armrests back, depress the release latch and pull arm toward back of
wheelchair.
J. FLIP-BACK HEIGHT ADJUSTABLE ARMRESTS
(optional) (Fig. 11)
Flip-back height-adjustable armrests are installed by Sunrise.
1. Height-Adjustment
a. Release the upper securing lever.
b. Slide armpad up or down to desired height.
c. Return lever to locked position.
2. Flipping Armrest Back and Removing Armrest
a. Depress the release latch and pull arm toward back of wheelchair.
b. To remove, pull up on armrest. Pin securing armrest will automatically release.
c. To return armrest to operating position, push armpad down until it locks firmly into place.
K. HEIGHT-ADJUSTABLE ARMRESTS
1. Installation
a. Slide the outer armpost into the receiver mounted to the wheelchair frame.
b. The armrest will automatically lock
into place.
2. Height Adjustment
a. Rotate release lever to second stop.
b. Slide armrest pad up or down to desired height.
c. Return lever to locked position against armpost.
d. Push arm pad until upper armpost locks firmly into place.
3. Removing Armrest
a. Rotate release lever to first stop and remove the armrest.
4. Replacing Armrest
a. Slide armrest back into receiver.
b. Return release lever to locked
position against armpost.
5. Adjusting Armrest Receive Fit
To tighten or loosen the fit of the outer armpost in the receiver:
a. Loosen the four bolts on the sides
of the receiver.
b. With the armrest in the receiver, squeeze the receiver to achieve the desired fit.
c. Tighten the four bolts.
6. Adjusting Inner Armpost Fit
a. Two set screws are installed in the outer armpost.
b. Turn the set screws in or out until
the desired fit is achieved.
L. CASTER PLATES
NOTE:
Use a torque setting of 75 in./lbs. when adjusting caster angle.
1. Angle Adjustment
a. Loosen the two eccentric bolts that secure the caster assembly. Do not remove the
clevis pin.
b. Place a large right triangle against the table surface and the front surface of the caster
bearing housing. This will align the caster stem rotational axis perpendicular to the
floor surface.
c. When alignment is satisfactory, retighten the two eccentric bolts.
d. Repeat the process for the other caster.
(Fig. 10)
(optional) (Fig. 12)
(Fig. 13)
Flip-Back Height Adjustable
Height Adjustable
15
IX. SET-UP & DJUSTMENT
1
4
2
6
5
3
1. Armrest pad
2. Upper securing lever
3. Release latch
4. Armrest panel
5. Rear receiver
6. Armrest release pin
4
5
3
8
2
7
9
6
1
1. Outer Armpost
2. Standard receiver
3. Release lever
4. Armrest pad
5. Transfer bar
6. Side panel
7. Outer armpost tension
adjustment set screws
8. Inner armpost
9. Receiver adjustment bolts
10
11
12
13
930360 Rev. E