Makita XMU04 Manual De Instrucciones página 10

3. Adjust the three pins so that they are lined up on
the alignment line.
► 1 . Alignment line
4. Apply a small amount of grease to the periphery
of the crank. Attach the crank to the pins with the small
and large rounds facing up.
► 1 . Crank
5. Adjust the blades and base plate so that the hole
in the base plate and the two protrusions on the blades
are lined up.
1
1
10 ENGLISH
6. Turn the shear blades upside down and install
them so that the pins on the tool fit in the hole on the
base plate. Make sure that the shear blades are fixed
securely in place.
7. Place the undercover so that
cover is aligned with
8. While pressing the undercover, turn the under-
cover clockwise until
with on the lock lever.
on the under-
on the lock lever.
on the undercover is aligned