2 Press either side of (DISC) to adjust
the desired volume level.
The volume level is adjustable by 1 dB
steps from –10 dB to +10 dB.
To restore the factory-set equalizer curve,
press (ENTER) for 2 seconds.
5
Press (MENU) twice.
When the effect setting is complete, the
normal playback mode appears.
Setting the Dynamic
Soundstage Organizer (DSO)
If your speakers are installed into the lower part
of the doors, the sound will come from below
and may not be clear.
The DSO (Dynamic Soundstage Organizer)
function creates a more ambient sound as if there
were speakers in the dashboard (virtual
speakers).
You can store the DSO setting for each source.
1
Press (SOURCE) to select a source
(radio, CD, or MD).
2
Press (DSO) repeatedly until "DSO
on" appears.
To cancel the DSO function, select "DSO off" in
step 2.
28
Selecting the spectrum
analyzer
The sound signal level is displayed on a spectrum
analyzer. You can select a display for ten patterns
(A-1 to A-5 or B-1 to B-5), or the automatic
display mode where all the patterns appear.
1
Press (SOURCE) to select a source
(radio, CD, or MD).
2
Press (MENU).
3
Press either side of (DISC) repeatedly
until "SA" appears.
4
Press either side of (SEEK) repeatedly
to select the desired setting.
5
Press (ENTER).