Symbols; Safety Warnings - Festool TDC 18/4 Manual De Instrucciones

English
Contents
1 Symbols..................................................... 14
2 Safety warnings.........................................14
3 Intended use..............................................16
4 Technical data........................................... 16
5 Parts of the device.....................................16
6 Battery pack.............................................. 17
7 Commissioning..........................................17
8 Settings......................................................17
9 Tool holder, attachments..........................18
10 Working with the electric power tool........18
11 Warning signals.........................................19
12 Service and maintenance..........................19
13 Environment.............................................. 19
14 General information.................................. 19
1

Symbols

Warning of general danger
Warning of electric shock
Read the operating instructions and
safety instructions.
Wear ear protection.
Wear a dust mask.
Wear protective goggles.
Wear protective gloves when changing
tools and working with raw materials.
Inserting the battery pack.
Remove the battery pack.
Hold in this position.
Only assemble by hand!
Do not dispose of it with domestic
waste.
CE marking: Confirms the conformity
of the power tool with the European
Community directives.
14
Tool contains a chip which stores data.
See section 14.1
Tip or advice
Handling instruction
2

Safety warnings

2.1 General power tool safety warnings
WARNING! Read all safety warnings, in­
structions, illustrations and specifica­
tions provided with this power tool. Failure to
follow all instructions listed below may result in
electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to
your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
Follow the operating manual for the charger
and the battery pack.
2.2 Machine-specific safety notices
Use the auxiliary handle(s). Loss of control
-
can cause personal injury.
- Hold the power tool by insulated gripping
surfaces, when performing an operation
where the cutting accessory or fasteners
may contact hidden wiring. Cutting acces­
sory contacting a "live" wire may make ex­
posed metal parts of the power tool "live"
and could give the operator an electric
shock.
- Use appropriate detection devices to look
for any hidden supply lines or consult your
local utility company. If the insertion tool
makes contact with live cables, it can result
in fire and electric shock. Damage to a gas
pipe can lead to an explosion. Penetration
of a water pipe can result in damage to
property.
Keep the power tool away from magnetic
-
fields. The power tool may switch on unex­
pectedly and cause injury.
-
Wear suitable personal protective equip­
ment: Ear protection, safety goggles, a dust
mask for work that generates dust.
CAUTION! Power tool can jam and cause
sudden kickback! Switch off immediately!