Slide Resistance; Throat Plate - Delta 26-2240 Manual De Instrucciones

SLIDE RESISTANCE

See Figure 34
The slide resistance (friction) on your saw is adjustable. Use an
5mm Hex wrench. Locate the friction adjustment screw on the
saw arms (A). Turn right to tighten the sliding friction. Turn left
to loosen the sliding friction.

THROAT PLATE

THROAT PLATE
Only use Delta® authorized service parts.
Using non-authorized parts can results in damage to your
machine and serious personal injury.
In the even that your throat plate needs to be replaced for any
reason, follow these instruction. See figures 35 and 36.
1.
Loosen the fence lock knobs. Slide both of the upper
(adjustable) fences completely off the lower (fixed)
fence.
2.
Remove the four screws (B) in the lower (fixed) fence
(C). Lift the fence off of the saw.
3.
Remove the six screws (D) which hold the throat plate.
Lift the throat plate off the miter arm.
4.
Replace the throat plate only using a Delta® authorized
service part.
5.
Tighten the six screws (D) which holed the throat plate.
6.
Re-install the lower (fixed) fence and tighten the four
screws (B) which hold it.
ADJUSTMENTS
22
A
LOOSEN
Figure 34
B
C
Figure 35
D
Figure 36
TIGHTEN