Operation Instructions - KOBE CH-97 Serie Instrucciones De Instalación Y Manual De Operación

OPERATION INSTRUCTIONS

This KOBE hood is equipped with four electronic controls with a 10-second standby startup & 30-
second delay shutoff, two powerful centrifugal turbine impellers with baffle filters, and two bright 12-volt
20-watt halogen lights/LED (if available).
The four electronic controls are Light Control, Speed Control A, Speed Control B and the Power Control
(On/Off). Refer to Figure 19.
Light Control
TURN ON:
x
Press Power Control (On/Off) button once.
(Note: If any control button is not pressed within 10 seconds, power will be automatically
turned off).
x
The KOBE hood will start on Low speed. Each press of the Speed Control button will
cycle through the various speeds.
x
Press Speed Control A button to cycle from Low, Medium, High, or QuietMode¥ ¥ ¥ ¥ .
Press Speed Control B button to cycle from Low, QuietMode¥ ¥ ¥ ¥ , High or Medium.
(Note: Speed Control A or B will operate both fans. These two speed buttons vary the
speed quicker.)
x
Press Light Control button to turn halogen light on.
TURN OFF:
x
Press Power Control (On/Off) button once, panel lights will flash and power will be
completely shut off after 30 seconds.
OR
x
Press Power Control (On/Off) button twice, all power will be shut off immediately.
x
If only the lights are on, pressing Power Control (On/Off) button once will turn power
off after 30 seconds.
Speed Control A
Speed Control B
12
Figure 19
Power Control