Operating Your Appliance; Control Panel Description; Operating Instructions; Getting Ice From Ice-Bin - Avanti IM12C-IS Manual De Instrucciones

Maquina de hacer hielo
Ocultar thumbs Ver también para IM12C-IS:
Tabla de contenido

Publicidad

 Control Panel Description
LED INDICATORS
POWER INDICATOR
The indicator above the word ICE will flash when the unit is plugged in.
It will lit green when the unit is turned on.
ADD WATER INDICATOR
The ice maker automatically checks the
water level in the tank. If the water level
is too low, the indicator will illuminate in
RED and will stop working automatically.
The 'ICE' indicator will
add water to the unit
and push the
ON/OFF button
the indicator will turn off
and will resume normal operation.
ICE FULL INDICATOR
When the ice-bin is full, the indicator will illuminate in RED. The indicator will remain lit until the ice
in the bin either melts away slowly or has been removed. The unit will stay in a "Standby" mode
until the ice has been removed / melted at which time the unit will automatically start operation as
normal.
Starting your Ice maker
Open the top cover and remove the ice basket.
Remove any dust or objects that may be in the water tank
Fill the water tank up to the area marked "MAX".
The ice-maker will automatically check the water level in the
reservoir periodically. The ice maker will detect any shortage
of water and will stop the ice-making cycle, then the ADD
WATER indicator will be lit.
Fill the reservoir with water and press the ON/OFF button to
restart the ice-making cycle and the ADD WATER indicator
goes out as the ice-maker will begin it's normal operation cycle automatically.
• When the ice cubes are collected and reach the bin sensor, the ice maker will stop
operating and the ICE FULL indicator will be lit.
• WARNING:
Direct sunlight may affect the infrared sensors and cause the unit to malfunction.
If at any time the unit does not stop the ice-making operation even when the ice-bin is full, move the
unit to another location where it is out of direct sunlight.
For best performance, water temperature should be between 7°C (45ºF) and 35°C (95ºF)
and ambient between 15°C (59ºF) and 25°C (77ºF).
Getting Ice from the Ice-bin
Open the top cover to access the ice basket.
Remove the amount of ice as desired and close the top.
OPERATING YOUR ICE MAKER
flash.Once you

Operating Instructions

9

Publicidad

Tabla de contenido
loading

Tabla de contenido