Prolonged Disuse - DURAVIT SensoWash Slim Manual De Instrucciones

5
200 ml
> Add 200
ml of water
(25-35°C ).
EN
The descaling process takes approx. 30 minutes. The shower
toilet functions are inactive during this time. SensoWash
flushed automatically with fresh water at the end of the des-
caling process so that the shower functions can be used again
immediately at the end of the process.

7.5 Prolonged disuse

If you do not use SensoWash
water inside the product.
Requirement: SensoWash
green illuminated.
> Disconnect the water supply.
> Press "Power"
> Now (within 2 seconds) press "Rearwash"
more than 10 seconds.
A confirmation tone is audible.
> Within 5 seconds release the buttons.
A confirmation tone is audible.
SensoWash
The "Status LED"
(approx. 1 minute) the product will enter "Standby mode" auto-
matically.
The "Status LED"
> Switch off the power supply.
> Remove the batteries from the remote control.
46
6
> Wait until
tablet is fully
dissolved (3
min.).
is in "On" mode, the "Status LED"
®
on the seat unit and keep it pressed.
A
will start the "internal drainage".
®
flashes orange. After the drainage is finished
B
is red illuminated.
B
7
00:03:00
> At the same time, press the
"Power"
buttons for 10 seconds.
E
> LED flashes green during
descaling process (duration:
30 min.).
for two weeks or above, drain the
®
00:00:10
and "Lady shower"
A
®
on the seat unit for
C
is
is
B