Additional Information; Precautions - Sony MDX-C8900R Manual De Instrucciones

Ocultar thumbs Ver también para MDX-C8900R:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Additional
Information

Precautions

• If your car was parked in direct sunlight
resulting in a considerable rise in
temperature inside the car, allow the unit to
cool off before operating it.
• If no power is being supplied to the unit,
check the connections first. If everything is in
order, check the fuse.
• If no sound comes from the speakers of a
two-speaker system, set the fader control to
the centre position.
• If your car is equipped with a power aerial, it
will extend automatically while the unit is
operating.
If you have any questions or problems
EN
concerning your unit that are not covered in
this manual, please consult your nearest Sony
dealer.
Moisture Condensation
On a rainy day or in a very damp area,
moisture may condense on the lenses inside
the MD player. Should this occur, the unit will
not operate properly. In this case, remove the
disc and wait for about an hour until the
moisture evaporates.
Notes on MDs
Since an MD itself is housed in a cartridge, free
from accidental contact with your fingers and
dust etc., it can withstand a certain degree of
the rough handling. However, dirt or dust on
the surface of the cartridge or a warped
cartridge may cause a malfunction quality,
observe the following.
Never touch the surface of the MD itself by
deliberately opening the shutter on the
cartridge.
40
Do not expose the MD to direct sunlight or
heat sources such as hot air-ducts. Do not leave
it in a car parked in the direct sunlight where
there can a considerable rise in temperature.
Make sure that it is not left on the dashboard
or rear tray of a car etc. where the temperature
can also be excessive.
Notes on mounting labels
Be sure to mount labels on cartridges correctly,
as failing to do so may cause an MD to become
stuck in the unit.
•Mount the label in a suitable position.
•Remove old labels before putting new ones
on.
•Replace labels that are beginning to peel
away from the MD.

Publicidad

Tabla de contenido
loading

Tabla de contenido