Garland BEST 100 DPE Manual De Instrucciones página 31

3
The plastic protector must be removed to work with
the cutting disc
The transmission can be locked
by inserting a tool or screwdriver
through the transmission hole and
the notch on the plate (6).
6.2.4. MOUNTING THE NYLON BUMP HEAD
Insert the coupling plate (6) to the transmission axis.
1
2
4
31/120
6.2.5. ASSEMBLY OF THE STEEL DISC
Insert the coupling plate (6) to the transmission axis.
1
3
6.2.6. CHANGING THE NYLON WIRE
Dismounting
1. To unscrew the bump head fully, introduce a
screwdriver on the coupling plate and the hole of
the transmission so as to block the piece. Unscrew
the bump head turning clockwise.
2. Unscrew clockwise the bottom part of the nylon
bump head.
3. Remove the bottom cover. Remove the empty nylon
charge and any remaining nylon thread.
Threading the new nylon
Cut approximately 4 meters of nylon thread. Hold the
both ends of the nylon thread, fold in two. Insert into
the nylon charger and coil both ends of the thread in
the same direction but each thread in its groove.
English
2
4