Transport, Storage, Decommissioning And Disposal - Yale Tigrip TTT Serie Manual De Instrucciones

18
The load lifting attachment must no longer be used in the case of wear in the bearing points
which is indicated by large play in the joints of the suspension eye, fish plates or clamping jaw.
Repair, i.e. replacement of the worn components is absolutely necessary, if the play between
clamping jaw and suspension eye exceeds 3 mm. Play is checked by holding the clamping jaw
with one hand and by moving the suspension eye back and forth in pulling direction with the
other. Before this check, disengage the spring.
Repairs may only be carried out by specialist workshops that use original TIGRIP spare
parts.
After repairs have been carried out and after extended periods of non-use, the load lifting
attachment must be inspected again before it is put into service again.
The inspections have to be initiated by the operating company.
T , S , D D
RANSPORT TORAGE ECOMMISSIONING AND ISPOSAL
Observe the following for transporting the unit:
• Do not drop or throw the unit, always deposit it carefully.
• Use suitable transport means. These depend on the local conditions.
Observe the following for storing or temporarily taking the unit out of service:
• Store the unit at a clean and dry place where there is no frost.
• Protect the unit against contamination, humidity and damage by means of a suitable cover.
• If the unit is to be used again after it has been taken out of service, it must first be inspected
again by a competent person.
Disposal:
After taking the unit out of service, recycle or dispose of the parts of the unit and, if applicable,
the operating material (oil, grease, etc.) in accordance with the legal regulations.
Further information and operating instructions for download can be found at
www.cmco.eu!
©
2016 Columbus McKinnon Industrial Products GmbH