Publicidad
Idiomas disponibles
Idiomas disponibles
TM12-1106-LG1
08/25/2017
mPro400GC-I global controller
m-Pro-400GC-I
Series
Tool Cable
5
Initial operation:
Putting into use
Danger of hands being crushed.
→ Always use a torque reaction bar for
applications in a restricted space or high
torque: inline tools (4 Nm), pistol grip tools
(10 Nm), right angle tools (60 Nm).
Application
Spindle Rotation
Isolation
Transformer
Tool Cable
Torque
Reaction
EN
Tool Cables
Cable Length
67EA series
Feet
Meters
Non European Union Cables - Matrix Connector
542778-XXX *
3 - 49
544056-XXX *
3 - 49
544055-XXX *
3 - 49
542779-XXX
3 - 66
European Union Cables - Matrix Connector
------------
------
------------
------
------------
------
------------
------
------------
------
* Note: 3 ft. and 6 ft. (1M and 2M) cables must be used with
542779 Extension Cable.
(1) Standard Durability
67EA Right Angle Nutrunner Shown
Performing a fastener rundown
The 67E series nutrunners have been configured by Apex
Tool Group. A setting for your specfic fastener joint must
only be made with the nutrunner controller by qualified
1
personnel
, The initial operation can vary depending on the
type and programming of the nutrunner controller. Refer to
the nutrunner controller Programming Manual.
→ Make sure the tool cable is securely attached to the tool
and controller.
→ Make sure the controller is powered on and properly
programmed (refer to the controller manuals).
→ Make sure the reverse mechanism is in the correct
position.
→ Place the socket or bit on the application and depress the
switch actuator to start the rundown.
→ When the nutrunner shuts off, release the switch actuator.
→ Remove the nutrunner from the application.
-------------------------------------------------------------------------------
1. Qualified personnel are those who can recognize possible
hazards and institute the appropriate safety measures due to their
professional training, knowl- edge, and experience as well as their
understanding of the relevant conditions pertaining to the work to
be done. Qualified personnel must observe the rules
Page 10
EN
Description
1 - 15 Tool Cable (1)
1 - 15 Swivel Cable: Inline (1)
1 - 15 Swivel Cable: Right Angle (1)
1 - 20 Extension Cable
------
------
------
------
------
------
------
------
------
------
Publicidad
