Dismounting, Return And Disposal - WIKA TR10-A Manual De Instrucciones

8. Maintenance ... / 9. Dismounting, return and disposal
8.3.4 Multipoint thermometers
(models TC94, Tx95, TC96-O, TC96-R, TC96-M, TC97)
The individual thermometers are calibrated before final assembly.
EN
8.3.5 Instruments with ceramic protection tube
(models TC80, TC82, TC83, TC84, TC85)
The minimum length (ceramic part of the probe) for carrying out a measurement accuracy
test 3.1 or DKD/DAkkS is 350 mm for standard versions. Calibration of instruments with
ceramic lengths of 200 mm to 350 mm on request.
8.3.6 Flush and in-line instruments
(models TR20, TR25)
The thermometer is immersed in a liquid bath for calibration.
8.3.7 Not calibratable
(models TR57-M, TR60, Tx90)
Standard versions of this instrument cannot be calibrated.

9. Dismounting, return and disposal

9.1 Dismounting
WARNING!
Physical injuries and damage to property and the environment
through residual media
Upon contact with hazardous media (e.g. oxygen, acetylene, flammable
or toxic substances), harmful media (e.g. corrosive, toxic, carcinogenic,
radioactive), and also with refrigeration plants and compressors, there is a
danger of physical injuries and damage to property and the environment.
▶
▶
▶
Only disconnect the thermometer once the system has been depressurised.
WARNING!
Risk of burns
During dismounting there is a risk of dangerously hot media escaping.
▶
26
Before storage of the dismounted instrument (following use) wash or
clean it, in order to protect persons and the environment from exposure to
residual media.
Use the required protective equipment (depending on the application; the
thermometer itself is basically not dangerous).
Observe the information in the material safety data sheet for the
corresponding medium.
Let the instrument cool down sufficiently before dismounting it!
WIKA operating instructions, models TRxx and TCxx