Declaration Of Conformity - SIOUX CN9BP Serie Instrucciones Y Lista De Piezas

Changing Heads.
1. Add a nut or short screw to the head assembly to retain the internal parts.
2. Loosen and remove the ring 44031A. (Left hand thread.)
3. Remove the head assembly and the hex drive bit.
4. Install the new head assembly making sure the hex bit is seated in the drive spindle and the fastener head. Remember that all stud-
type tools use the same bit, but each nut-type head uses a bit matched to the arbor size.
5. Replace and tighten the ring.
6. Remove the retaining nut or screw before operating the tool.
We, Sioux Tools Inc., 250 Snap-on Drive, P.O. Box 1596, Murphy, NC, 28906, USA, declare under our sole responsibility that the products
to which this declaration relates are in conformity with the following standard or standards or other normative document or documents:
July 1, 2003
Murphy, North Carolina, USA
Date and place of issues
SOUND AND VIBRATION READINGS
*Sound Pressure
Catalog No. dBA
CN9BP-4** 77.9
CN9BP-7** 77.9
CN9BP-12** 77.9
CN9BP-20** 77.9
CN9BP-25** 77.9
CN9BP-44** 77.9
*per PN8NTC1
**Including all suffixes

DECLARATION OF CONFORMITY

CN9BP-4, CN9BP-7, CN9BP-12, CN9BP-20, CN9BP-25, CN9BP-44
Including all suffixes
EN 792 (draft), EN 292 Parts 1&2, ISO 8662, Pneurop PN8NTC1
following the provisions of
89/392/EEC as amended by 91/368/EEC & 93/44/EC Directives.
Gerald E. Seebeck
Name and position of issuer
*Sound Power
dBA
89.5 Less than 2.5
89.5 Less than 2.5
89.5 Less than 2.5
89.5 Less than 2.5
89.5 Less than 2.5
89.5 Less than 2.5
*per PN8NTC1 *per ISO 8662
President
Sioux Tools Inc.
2
*Vibration
m/s 2
Signature of issuer