Hansgrohe adesso Talis C 33100000 Instrucción De Montaje página 7

Attention! The fitting must be installed,
flushed and tested after the valid norms.
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin.
3. Slip the fixation piece including the washer over
the threaded pins and tighten the nuts.
4. Connect the supply pipes to the isolation valves;
cold right - hot left.
5. 33101000 / 33121000: Connect the pull rod
to the pop-up waste.
Large differences in pressure between the hot and
cold water supply must be balanced.
Operation
The mixer is activated by lifting the lever handle.
Move to the left = hot water,
move to the right = cold water.
Technical Data
This mixer series-produced with waterdim-
mer (flow limiter)
Rate of flow with waterdimmer:
Rate of flow without waterdimmer:
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
6
English
Hansgrohe single lever mixers can be used toge-
ther with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 1.5 bars.
If the continuous flow heater makes any problems or
there comes not enough water, the flow limiter (6a)
located behind the mousseur must be removed.
To adjust the hot water limiter on single lever mixers,
please see page 14.
No adjustment is necessary when using a continuous
flow water heater.
Spare parts (see page 3)
1
1.1 screw cover
2
3
4
5
6
7
8
9
10 ball joint
7 l/min 3 bars
Special accessories
14l/min 3 bars
X
max. 10 bars
1 - 5 bars
16 bars
max. 80° C
65° C
handle
flange
nut
cartridge, assy
seal
aerator cpl.
fixing set
connection hose 450 mm
pull rod
special tool set
(not part of delivery)
33092000
96338000
94192000
94194000
92730000
95008000
13912000
96016000
95001000
96657000
92036000
58085000