Preparing A Cappuccino With The Automatic Cappuccino Maker (Optional); Hot Water; Cleaning And Maintenance - La Pavoni LPMGCM03 Manual De Uso

• Move the steam lever switch (11) to
position "0".
• Pour the frothed milk into the cups
containing the espresso.
In order for the machine to
operate correctly, do not dispense
steam for more than 60 seconds.
For reasons of hygiene, it is
advisable to clean the frothing
nozzle for cappuccino after use.
The more you turn the knob,
the greater will be the steam
pressure.
4–4. PREPARING A CAPPUCCINO WITH
THE AUTOMATIC CAPPUCCINO MAKER
(OPTIONAL)
The turbo steam device (6) should be
replaced with the Automatic Cappuccino
maker before starting the machine.
Proceed as follows:
• Loosen the upper locking ring (A) of
the turbo steam nozzle (6) (Fig. D) by
turning it anticlockwise
• Remove the turbo steam device (6)
from the seam nozzle Fig. E by pulling
it downwards.
• Insert the Automatic Cappuccino
maker onto the steam nozzle by
pushing it upwards until the nozzle
rests against the fitting and tighten
the locking ring by turning it clockwise.
Prepare the espresso coffee in a
cappuccino cup.
• Then, once the machine is ready to
dispense steam, proceed as follows.
• Insert the suction tube (B) (Fig. E) of
the Automatic Cappuccino maker into
the container containing the cold milk.
• Place the cup containing the previously
prepared coffee under the nozzle
of the Automatic Cappuccino maker
and open the steam knob (4) by
turning it anticlockwise. This will start
to dispense hot milk, with abundant
froth.
• To stop dispensing, close the steam
knob (4) by turning it clockwise.
You can regulate the froth by
adjusting the pin (C) (Fig. E), of the
Automatic Cappuccino maker to
get the required consistency of
the froth. Move the pin upwards
to obtain a froth with a greater
volume.
In order for the machine to
operate correctly, do not dispense
steam for more than 60 seconds.
4–5. HOT WATER
• Make sure that you have carried out all
operations in section 4.1
• Place a container under the frothing
nozzle (6)
• Open the knob (4) and move the
coffee / hot water lever switch (10) to
position "I". This will dispense water
immediately from the turbo steam
nozzle (6).
• Once the required amount of water
has been dispensed, move the coffee
/ hot water lever back to position "0"
and close the knob (4).
• After dispensing hot water, make sure
that there is still water in the tank (1).
The water is dispensed at a very
high temperature. Be careful to
avoid possible scalding.

5. CLEANING AND MAINTENANCE

Before carrying out any cleaning or
maintenance, unplug the power cable
from the power outlet without pulling
the cable.
Do not immerse the coffee
machine in water or other liquids.
26