Gardigo 78540 Manual De Instrucciones página 11

Important: If your car has a CAN/BUS connect the cable to the fuse of terminal 15.
• If the connection to terminal 15 doesn't work or is not available, then it is also pos-
sible to install the device in an area of the engine compartment which is subject
to high vibrations. The vibrations of the engine will switch the device automatically
off. When the engine is not running the device will automatically switch on after 60
seconds.
• Install the high-voltage plates [ / ] in areas where marten is most likely to pass
by. The plates have 3.1 mm holes in the corners with which they can be assembled in
the engine compartment, either with tapping screws or cable ties.
When installing the high volt plates please make sure of the following points:
• The high-voltage contact modules must be installed in the engine compartment in
such a way that the marten inevitably has to touch two contact plates when entering it.
• Make sure that the cables are not installed near movable or hot parts of the engine.
• A direct contact between the „plus" and „minus" plates or with the chassis of the car
can result in a short-circuit and the destruction of the device.
• Flashovers from the plates to parts of the car electronics cannot happen as the volt-
age of 400 +/– 50 Volt can only create a spark of 0,7 mm length. A distance of 5 mm
to all other electronic components will eliminate any potential danger of damage.
High Voltage! Please install the included yellow warning stickers by placing
them in locations that are seen immediately when opening the bonnet.
• Install the fuse and start the device by pressing the On/Off button. The red [ ] and
white [ ] LED will light up, if the device is installed correctly.
• The red LED 1 will flash every 22 seconds and when the ultrasonic frequencies activat-
ed. The white LED [ ] will flash 3 – 4 times if an intruder has triggered the system by
touching the high volt modules. This is an additional deterrent against the marten.
Note: If the voltage of the car battery goes below 11 V, the Marder Shock Plus will au-
tomatically switch itself off. This will save the battery from total discharge. When the
"Car-Battery-Controll" (CPC) is activated, the device will offer no protection against an
intruder. As soon as the voltage of the car battery goes above 12 V, the device will auto-
matically be activated again.
Danger High Voltage! Before servicing your engine compartment it is rec-
ommended to detach the device from the battery or to switch it off with
the On/Off switch. Please wait at least three minutes for the high voltage
automatically reduce itself.
Note: The response of each animal to our devices may vary. The development of our de-
vices, methods and application tips are based on experience, testing and feedback from
our customers. Therefore the devices are successful in most cases.
11