ADJUSTEMENT OF THE LIMIT SWITCHES
TM2 M tubular motors are provided with a system of electromechanical limit
switches that stop the feed when the awning or the rolling shutter get to the maxi-
mum opening or closing limits. To adjust these limits and adapt them to any need,
simply screw or unscrew the two adjusting screws on the motor head. The limits of
the limit switches are preset at about three turns of the roller.
1. To decide which adjusting screw to fix, simply watch the direction of rotation of
the stop ring nut: if the stop ring nut pulled by the roller goes in direction A, use the
adjusting screw A to set the limit switch in that direction. If it goes to the opposite
direction (B), use the adjusting screw B.
2. Start up the awning or the rolling shutter in the direction in which you wish to
set the first limit switch. After a few turns the motor will stop on the preset stop.
3. Screw the adjusting screw suited to the direction (see point 1.) in direction "+"
till it gets to the chosen position.
4. Invert the engine sense of direction and set the second limit switch.
ADJUSTING SCREWS
ADJUSTING SCREWS
B
A
A
B
A
A
B
STOP RING NUT
B
STOP RING NUT
TM2 M
10
A4516_6G35_Rev.A