Publicidad
Idiomas disponibles
Idiomas disponibles
8
- Insert the key and check whether the wafers with number 1 fi t.
- Replace wafers that do not fi t with wafers with the right number.
NOTE
The wafers should be aligned fl ush with the locking cylinder. The
number of visible grooves indicates which wafer needs to be used.
This example shows a cylinder in which three wafers with number
1 have been installed. Two grooves are visible on each of the two
protruding wafers. This means that wafers with number 3 need to be
installed instead.
It is advisable to note down which numbers the fi tting wafers have
so that the other locking cylinders can be assembled in the same
manner.
- Repeat the steps for the slots
are equipped with the right wafers.
- Insert the spring for locking plate
NOTE
The slots
and
remain empty.
- Mount O-ring
.
- Position and insert the lock cylinder as shown in the fi gure (Cylin-
der cam must face upwards).
Please read though the following instructions before using the
case, and please note the warning label inside the case!
,
and
until the fi rst six slots
and locking plate
into slot
.
Publicidad
