Filling The Magazine; Eu Declaration Of Conformity - KMR 3489 Serie Manual Del Usuario

Device-specific additional instructions for nailer
4

Filling the magazine

Ensure that nailer and fasteners are compatible (Chap. 1) with
•
each other.
Check fasteners for proper condition.
•
Put nailer carefully down in defined safe resting position (Chap. 3):
•
The driving nose must point away from any person. It must be
impossible to unintendly actuate trigger and/or release protection.
Press the latch button 1 and push the magazine cover 2 to the rear.
•
Insert the round head nails with the tips at the bottom into the
magazine 3. Then push the magazine cover 2 forward
5 Adjusting drive-in depth
Reduce pneumatic operating pressure as far as possible to
•
minimize blowback, noise and air consumption (see General
operating instructions).
Mechanical adjustment of drive-in depth:
Disconnect the tool from the compressed air supply. Turn
•
adjustment knob 1 for deeper countersunk nails clockwise. Turn
anti-clockwise to lower the nails less deeply.
6 Changing the trigger setting
Disconnect
the unit from the compressed air supply, press button
•
the valve lever from behind and with the other hand set it to single
release (symbol 1 nail) or contact release (symbol with 3 nails).
Reconnect the tool to the pressure source.
#
7 Removing stuck fasteners from the driving channel
Disconnect the tool from the compressed air supply. Remove the
•
staples from the device. Actuate the locking lever 1 and open
the head piece flap 2. Remove jammed staples. Close the head
piece flap 1 again, connect the tool to the pressure supply and
refill the magazine with staples.
8

EU Declaration of conformity

The BeA GmbH, manufacturer or importer, address as on cover sheet, declares under sole responsibility this product's conformity with all
relevant provisions of the EU Machine Directive 2006/42/EG. The following standards are applied:
EN ISO 12100:2010 (Machine safety); ISO 11148-13:2017-11 (Hand-held non-el. machines - Fastener driving tools);
EN 12549:1999+A1:2008 (Noise measuring for driving tools); ISO 8662 (Vibrations at driving tools).
------------------------------------------
Dr. Jörg Dalhöfer, CEO
.3489
.
1 on
-----------------------------------------------------------
Joachim Bauer, Documentation responsible
EN - 13