Würth DIGA CSM-1 POWER Traducción Del Manual De Instrucciones De Servicio Original página 36

Setting the fastener seating depth
Danger
For safety reasons always remove the
battery and the gas cartridge from the
device prior to adjusting works!
Warning
The adjustment dial can get very hot
during operation.
Transport & storage
Danger
At the end of the working day, during
longer breaks, when transporting and
storing, always remove the battery and
the gas cartridges from the device.
Store the device and the battery in the genuine tool
box on a safe, dry, heat- and frost-proof place.
Always store gas cartridges separately and on a
save place. Unauthorized persons, in particular
children, may not get access to the device or to gas
cartridges.
Maintenance / care
To ensure trouble-free and safe working, the tool
must be regularly maintained. Please carry out
annual maintenance on the device (earlier if requi-
red). Use only Würth spare parts for maintenance.
Danger
Never disassemble the tool with cart-
ridges still inserted.
Wear safety goggles!
Due to the released pressurised air,
parts may be stirred up causing eye
injuries.
Cleaning the filter pad
Attention
Do never clean the housing opening
by means of pressurized air otherwise
dirt may get in the engine compartment
and damage the engine.
If exposed to great amounts of dust, the filter
■
pads must be cleaned after each working day.
Unscrew the cap with filter pad [1] and remove
■
for cleaning.
36
Clean filter pad using the compressed air or
■
replace in the case of heavy soiling.
Cleaning the ejection channel and the
magazine
Clean the ejection channel, sleeve and the guide
■
rail in the magazine regularly to reduce the risk of
jams and to prevent increased wear.
Do not lubricate moving parts.
■
Cleaning the housing
Clean the housing with a clean dry cloth.
■
We recommend to use Würth plastic cleaners and
■
Würth plastic care products.
Remove heavy soiling (dust etc.) using a soft brush.
■
Disposal
Disposal must be carried out in accordance with
■
official regulations.
Dispose of contents/containers in accordance with
■
the sorting instructions provided by the licensed
waste collector.
Further information can be found in the section
■
entitled Disposal
If, in spite of careful manufacturing and test procedu-
res, the device becomes faulty, contact Würth master-
Service to arrange a repair. . With any enquiries or
spare parts orders, always quote the item number as
given on the device type plate.
The latest spare parts list for the device is available
online at http://www.wuerth.com/partsmana-
ger. Alternatively, contact your local Würth agency for
a hardcopy.
Disposal
Electrical power tools, accessories and packaging
should be sorted and submitted to an environmentally-
sound recycling facility.
EU countries only:
Do not dispose of your power tool
with the household waste.
In accordance with the European
Directive 2002/96/EC on Waste
Electrical and Electronic equipment
and its implementation into national
law, electrical devices that are no longer usable must
be collected separately and routed to an environmen-
tally-friendly recycling/recovery chain.
Batteries:
Do not dispose of batteries in household waste, do not
expose to fire or water. Collect and recycle batteries or
dispose of with due care for the environment.