Preparation For Video Cd Playback - Sharp CD-BK3030V Manual De Manejo

Preparation for Video CD Playback

! Adjusting the TV and VCR
The TV and VCR input varies according to connection method. Be sure to make the
settings correctly. (Then, follow the playback procedure on pages 17 - 18 to check the
settings.)
<For TV sets with a video input socket>
Set the input selector
to VCR.
<For TV sets without a video input socket>
Set the input selector
to AUX.
Set the TV/VCR selector
to VCR.
VCR
! Selecting the video output format
Video CD is recorded in PAL or NTSC format.
Select the video output format (NTSC or PAL) according to your TV or VCR.
To select the video output format:
Whilst in the stop mode, press the PAL/NTSC button.
Each time this button is pressed, the format will change in the following order:
TV
Notes:
" Video CDs are recorded in PAL or NTSC format. When you watch a PAL disc in
" If a multi-mode TV is equipped with an input selector switch, set the switch to
" Do not change the video output format during playback. If you do, the picture sig-
" Picture may be distorted when the setting is switched. This is not the malfunction
" A few hours after the unit is unplugged, the setting will change back to the state at
TV
Set the input selector
to VCR.
the NTSC mode or an NTSC disc in the PAL mode, the vertical size of the picture
will not be modified.
"MULTI MODE". For the details, refer to the TV operation manual.
nal may not be output properly.
of the unit.
the factory shipment (default setting). The setting details vary depending on areas.
01/10/12 CD-BK3030V(X)E2.fm
CD-BK3030V
NTSC PAL
ENGLISH E-16