Remote Control - Sharp CD-BK137W Manual De Manejo

Ocultar thumbs Ver también para CD-BK137W:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

„ Setting the FM/AM span selector
The International Telecommunication Union (ITU) has established that member coun-
tries should maintain either a 100 kHz or a 50 kHz interval between broadcasting fre-
quencies of FM stations and 10 kHz or 9 kHz for AM station. The illustration shows
the 50/9 kHz zones (regions 1 and 3), and the 100/10 kHz zone (region 2).
Before using the unit, set the SPAN SELECTOR switch (on the rear panel) to the
interval (span) of your area.
To change the tuning zone:
1 Press the ON/STAND-BY button to enter the stand-by mode.
2 Set the SPAN SELECTOR switch (on the rear panel) as follows.
z For 50 kHz FM interval (9 kHz in AM)
z For 100 kHz FM interval (10 kHz in AM)
3 Whilst pressing down the
/
button and the EQUALIZER/X-BASS/DEMO but-
ton, press the ON/STAND-BY button until "CLEAR AL" appears.
Caution:
This operation will erase all data stored in memory including clock, timer settings,
tuner preset, and CD programme.

Remote control

„ Battery installation
1 Remove the battery cover.
2 Insert the supplied batteries according to the direction indicated in
3 Replace the cover.
Precautions for battery use:
z Replace all old batteries with new ones at the same time.
z Do not mix old and new batteries.
z Remove the batteries if the unit will not be used for long periods of time. This will
Caution:
z Do not use rechargeable batteries (nickel-cadmium battery, etc.).
z Installing the batteries incorrectly may cause the unit to malfunction.
Notes concerning use:
z Replace the batteries if the operating distance is reduced or if the operation
z Periodically clean the transmitter on the remote control and the sensor on the unit
z Exposing the sensor on the unit to strong light may interfere with operation.
z Keep the remote control away from moisture, heat, shock, and vibrations.
„ Test of the remote control
50/9
Face the remote control directly to the remote
100/10
sensor on the unit.
The remote control can be used within
the range shown:
Press the ON/STAND-BY button. Does the pow-
er turn on? Now, you can enjoy the music.
the battery compartment.
When inserting or removing the batteries, push them towards the
nals.
prevent potential damage due to battery leakage.
becomes erratic. Purchase 2 "AA" size batteries (UM/SUM-3, R6, HP-7 or similar).
with a soft cloth.
Change the lighting or the direction of the unit.
01/8/28
CD-BK137W(X)E1.fm
CD-BK137W
battery termi-
Remote sensor
0.2 m - 6 m
(8" - 20')
ENGLISH
E-10

Publicidad

Tabla de contenido
loading

Tabla de contenido