Publicidad
Idiomas disponibles
Idiomas disponibles
Unplug the power cord from mains socket before commencing any activities related to installation,
adjustment, repair or maintenance.
● Cleaning the device after each use is recommended.
● Do not use water or any other liquid for cleaning.
● Clean the tool with a dry cloth or blow with compressed air at low pressure.
● Do not use any cleaning agents or solvents, they may damage plastic parts.
● Clean ventilation holes in the motor casing regularly to prevent device overheating.
● Regular lubrication of guiding roller is recommended. A drop of oil applied in this spot will prolong
lifetime of the roller.
● In case of power cord damage replace it with a cord with the same specification. Entrust the repair to
a qualified specialist or return the tool to a service point.
● In case of excessive commutator sparking, have the technical condition of carbon brushes of the
motor checked by a qualified person.
● Always store the tool in a dry place, beyond reach of children.
REPLACEMENT OF CARBON BRUSHES
Immediately replace worn out (shorter than 5 mm), burnt or cracked motor carbon brushes. Always
replace both carbon brushes at a time.
Entrust replacement of carbon brushes only to a qualified person. Only original parts should be
used.
All defects should be repaired by service workshop authorized by the manufacturer.
RATED PARAMETERS
Parameter
Supply voltage
Power supply frequency
Rated power
Blade stroke cycles (without load)
Maximum thickness of cut ma-
terial
Blade stroke length
Laser class
Laser power
Laser wavelength
Protection class
Weight
Year of production
NOISE AND VIBRATION DATA
Information regarding noise and vibration
The following levels of emitted noise, such as emitted acoustic pressure Lp
and measurement uncertainty K have been given in the instruction manual as defined in the EN 60745
standard.
The following vibration value (acceleration value) a
ned as defined in the EN 60745-2-11 standard.
OPERATION AND MAINTENANCE
TECHNICAL PARAMETERS
Jigsaw
Wood
Metal
and measurement uncertainty K have been determi-
h
21
Value
230 V AC
50 Hz
800 W
500-3000 min
-1
80 mm
10 mm
20 mm
2
< 1mW
λ = 650 nm
II
2,45 kg
2015
and acoustic power level Lw
A
A
Publicidad
