Black and Decker DV1205EN Traducción De Las Instrucciones Originales página 7

the liquid off using a cloth. Avoid skin
contact.
In case of skin or eye contact, follow

the instructions below.
Warning! The battery fluid may cause
personal injury or damage to property. In
case of skin contact, immediately rinse
with water. If redness, pain or irritation
occurs seek medical attention. In case of
eye contact, rinse immediately with clean
water and seek medical attention.
Chargers
Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate.
Warning! Never attempt to replace the
charger unit with a regular mains plug.
Use your Black & Decker charger

only to charge the battery in the
appliance/tool with which it was
supplied. Other batteries could burst,
causing personal injury and damage.
Never attempt to charge non-

rechargeable batteries.
If the supply cord is damaged, it must

be replaced by the manufacturer or
an authorised Black & Decker
Service Centre in order to avoid a
hazard.
Do not expose the charger to water.

Do not open the charger.

Do not probe the charger.

The appliance/tool/battery must be

placed in a well ventilated area when
charging.
Safety of others
This appliance is not intended for use

by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience
and knowledge, unless they have
been given supervision or instruction
concerning the use of the appliance
by a person responsible for their
safety.
Children should be supervised to

ensure that they do not play with the
appliance.
ENGLISH
Electrical safety
Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate. Never attempt to
replace the charger unit with a regular
mains plug.
Symbols on the charger
Your charger is double
insulated; therefore no earth
wire is required.
Read all of this instruction
manual carefully.
Fail-safe isolating transformer.
The mains supply is electrically
separated from the transformer
output.
The charging base is intended
for indoor use only.
Features
1. Dust collector extension
2. Dust collector
3. Release button
4. On/Off switch
5. Charging indicator
6. Filter cleaning button
7. Charging base
Fig. A
8. Crevice tool
9. Brush tool
Installation
Fitting the charging base to the wall
The charging base can be placed on a
work top or fitted to the wall to provide a
convenient storage and charging point for
the appliance.
When fixing to a wall, make sure that the
fixing method is suitable for the wall type
and is appropriate to the weight of the
appliance.
7