Ambient Temperature; Moving Your Appliance - Saivod VSC3318D Manual Del Usuario

To ensure adequate ventilation for the appliance, allow a minimum of 10 cm of airspace on
each side of the cabinet.
For uneven surfaces, front feet can be aligned.

AMBIENT TEMPERATURE

This appliance is designed to operate in ambient temperature between 10°C and 32°C.If these
temperatures are exceeded, i.e. colder or warmer, the appliance will not operate correctly.

MOVING YOUR APPLIANCE

• Make sure that the appliance is unplugged from the mains socket. Remove all bottles and
shelves to avoid any shock.
• Always move the appliance vertically.
• After moving, wait for 30 minutes before plugging in the appliance.
Your appliance uses isobutane (R600a) as a refrigerant. Although R600a is an
environmentally friendly and natural gas, it is explosive. Therefore you should be careful
during shipment and installation to prevent your appliance's cooler elements from being
damaged. In the event of a leak caused by damage to the cooler elements, move your
appliance from open flame or heat sources and ventilate the room where the appliance is
located for a few minutes.
BEFORE FIRST USE
• Remove all packaging.
• Clean the inside of the appliance with warm water and a little liquid detergent to remove
manufacturing and transportation dust.
OPERATION
Ensure that the appliance is placed on a flat and stable surface.
Plug the appliance into the mains socket. The display will show the current actual temperature
of the internal cabinet.
Allow the appliance to cool down for 2-3 hours before placing wine bottles in the appliance.
GB
SELECTING THE TEMPERATURE
The temperature can be set from 4°C to 18°C. The default factory temperature is set at 12°C.
1. Repeatedly press to select the required temperature.
• Each time you press the temperature will be increased or decreased by 1°C.
2. The temperature selected will flash on the display for approximately 3 seconds, then the
display will return to the current actual temperature of the internal cabinet.
• The current actual temperature will vary depending on the quantity of bottles stored and
how often the door is opened.
• To view the set temperature, press , the set temperature will flash on the display
for approximately 3 seconds and then return to the current actual temperature of internal
cabinet.
• The temperature display can be switched between Celsius (°C) and Fahrenheit (°F) by
pressing and holding. The corresponding indicator light °C or °F will illuminate.
25
VSC3818D.indd 25 2018/8/14 14:28:13