Publicidad
Step 11
Insert the dowel end of two TWIST-LOCK® FASTENERS (JJ) into the TOP (E2) as shown in the enlarged diagram.
å
NOTE: If you already pushed TWIST-LOCK® FASTENERS into the large holes in the BACKS (G), pull the FASTENERS back
å
out of the holes. Pull at the front and back edges, slowly working the FASTENERS out of the holes.
1. At an angle, push the long edge with holes in the BACKS (G) onto the CAM SCREWS in the LEGS (J).
å
2. Now, swing in the opposite long edge of the BACKS (G) so the TWIST-LOCK® FASTENER in the TOP (E2) pushes into
å
the large holes in the BACKS. Tighten two TWIST-LOCK® FASTENER and four HIDDEN CAMS.
Fasten the BRACES (H) to the UPRIGHTS (C and D). Tighten four HIDDEN CAMS.
å
Surface with
HIDDEN CAMS
H
These holes must be here.
Page 16
These holes must be here.
Unfi nished
surface
G
C
E2
These holes must be here.
J
Surface with
HIDDEN CAMS
H
D
409042
J
These holes must be here.
1. Push this long
edge over the
CAM SCREW.
G
U n
fi n
s u
i s h
r f a
e d
c e
2. Swing this
edge in over the
TWIST-LOCK®
FASTENER.
JJ
E2
www.sauder.com/services
G
Publicidad
