Technical Notes
Technical Notes
Specifi cations
Specifi cations
Maximum depth
Camera operating temperature 0 °C–40 °C (32 °F–104 °F)
Dimensions (W × H × D)
Weight
Optional Accessories
Optional Accessories
The following optional accessories are available for the waterproof case:
• WP-ZG1000 zoom gear sleeve
• WP-IR1000 inner-refl ection
En
prevention ring
• WP-LC1000 front cap
• WP-AN2000 front cap strap
SEA&SEA YS-D1 Underwater Flash Units
A
The waterproof case is equipped with 2 fi ber-optic cable
sockets, permitting underwater fl ash units to be connected
via optional SEA&SEA fi ber-optic cables and controlled by
the camera's built-in fl ash. When using an underwater fl ash
unit, remove either of the fi ber-optic cable socket caps (
note that although there is no risk of leaks when the caps
are removed, the caps for unused sockets should be left in
place), connect the cable (
era's built-in fl ash before placing the camera in the case, as
once placed in the case the fl ash may fail to pop up on its
own. Before using the fl ash underwater, take a test shot and
confi rm that the fl ash is functioning normally. For more in-
formation, see the camera manual and the documentation
provided with the fl ash unit.
21
40 m (130 ft)
Approx. 156 × 116 × 128 mm (6.2 × 4.6 × 5.1 in.), excluding
projections
Approx. 750 g (26.5 oz), body only
• WP-AN1000 strap
• WP-O1100 O-ring
• WP-OR1000 O-ring remover
• WP-G1000 silicon grease
• WP-S1000 silica gel desiccant
w
), and be sure to raise the cam-
q
;