Bosch PSR 7,2 LI Manual Original página 26

OBJ_BUCH-781-004.book Page 26 Tuesday, September 6, 2011 3:13 PM
26 | English
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Engineering Director
Engineering PT/ESI
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
01.09.2011
Assembly
Before any work on the machine (e. g., maintenance, tool change,
etc.) as well as during transport and storage, set the rotational di-
rection switch to the centre position. Unintentional actuation of the
On/Off switch can lead to injuries.
Battery Charging (see figure A)
Do not use other battery chargers. The supplied battery charger is
designed for the Lithium-Ion battery in your machine.
Observe the mains voltage! The voltage of the power supply must
correspond with the data given on the nameplate of the battery charg-
er. Battery chargers marked with 230 V can also be operated with
220 V.
Note: The battery is supplied partially charged. To ensure full capacity of
the battery, completely charge the battery in the battery charger before
using your power tool for the first time.
The lithium-ion battery can be charged at any time without reducing its
service life. Interrupting the charging procedure does not damage the bat-
tery.
The lithium-ion battery is protected against deep discharging by the "Elec-
tronic Cell Protection (ECP)". When the battery is empty, the machine is
switched off by means of a protective circuit: The inserted tool no longer
rotates.
Do not continue to press the On/Off switch after
WARNING
the machine has been automatically switched
off. The battery can be damaged.
2 609 005 644 | (6.9.11) Bosch Power Tools