Bosch PSR 7,2 LI Manual Original página 27

OBJ_BUCH-781-004.book Page 27 Tuesday, September 6, 2011 3:13 PM
The charging procedure starts as soon as the main plug of the battery
charger is inserted into the socket and the cordless screwdriver is after-
wards placed on the battery charger 11.
The battery charge-control indicator 5 indicates the charging progress.
During the charging procedure, the indicator flashes green. The battery
is fully charged when the indicator lights up green continuously.
During the charging procedure, the handle of the machine warms up. This
is normal.
Disconnect the battery charger from the mains supply when not using it
for longer periods.
The power tool cannot be used during the charge procedure; it is not de-
fective when inoperative during the charging procedure.
Observe the notes for disposal.
Changing the Tool (see figure B)
Do not use double-sided screwdriver blades that are longer than
25 mm.
Insert the screwdriver bit 1 directly into the tool holder 2.
Operation
Starting Operation
Reversing the Rotational Direction (see figure C)
The rotational direction switch 9 is used to reverse the rotational direction
of the machine. However, this is not possible with the On/Off switch 8 ac-
tuated.
Right rotation: For driving in screws, push the rotational direction switch
9 left to the stop.
The indicator for right rotation 4 lights up when the On/Off
switch 8 is actuated and the motor is running.
Left Rotation: For loosening or unscrewing screws, push the rotational
direction switch 9 right to the stop.
The indicator for left rotation 6 lights up when the On/Off switch
8 is actuated and the motor is running.
Bosch Power Tools
English | 27
2 609 005 644 | (6.9.11)