Cleaning/Replacing The Air Filter; Maintaining The Spark Plug; Changing The Engine Oil - Deltafox DG-PLM 4622 SP Traducción Del Manual De Instrucciones Original

GB
Do not tilt the equipment sideways
or forwards. Operating fluids could
leak out and the engine could be
damaged.
• Always keep the equipment clean. To
clean, use a toothbrush or cloth but no
corrosive cleaning agents or solvents.
Do not use water to clean the engine as
it could contaminate the fuel system.
To clean the blade housing, it is possi-
•
ble to connection a hose to the upper
side of the housing (
(see 33).
• After mowing, remove plant remains
that are stuck to the equipment by us-
ing a piece of wood or plastic. Clean
the vent holes (
and blade area especially. Do not use
hard or pointed objects, which could
damage the equipment.
• Oil the wheels from time to time.
• Before each use, check the lawnmow-
er for obvious defects such as loose,
worn or damaged parts. Check that
all nuts bolts and screws are sitting
firmly.
• Check covers and guards (
15, 23) for damage and that they are
sitting correctly. Replace if necessary.
Cleaning/Replacing the Air
Filter
Do not operate the equipment
without the air filter otherwise dust
and dirt will get into the engine and
result in damage to the machine.
1. Remove the spark plugs con-
nector (
the Spark Plug").
2. Open the air filter box (10) and
take out the air filter (11).
90
17)
12), ejection hole
3, 12,
13) (see "Maintaining
3. Clean the air filter (11) with soap
solution and let it dry. Put a few
drops of fresh engine oil into the
air filter.
4. To install, place the air filter (11)
in the air filter box (10) and re-
close it.

Maintaining the Spark Plug

A worn spark plug or a spark gap
that is too large will result in a re-
duction of engine performance.
1. Disconnect the spark plug con-
nector (13) from the spark plug
(14) by simultaneously pulling
and turning.
2. Unscrew the spark plug (14) an-
ticlockwise.
3. Check the spark gap using a
feeler gauge (available from
specialist shops). The spark gap
must be at least 0.5-0.6 mm.
4. If necessary, adjust the gap by
carefully bending the ground
electrode on the spark plug.
5. Clean the spark plug with a wire
brush.
6. Insert the cleaned and adjusted
spark plug or replace a dam-
aged spark plug with a new one
(recommended torque 20 Nm,
determined with a torque
wrench) (see "Replacement
parts/Accessories").

Changing the Engine Oil

Change the engine oil with the
petrol tank empty and the engine
warm.