Operation; Starting And Stopping The Engine - Deltafox DG-PLM 4622 SP Traducción Del Manual De Instrucciones Original

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 150
GB
-
Remove spilt petrol;
-
Keep petrol away from sparks, open
flames and other ignition sources;
-
Dispose of leftover petrol in an envi-
ronmentally friendly way (see "Dis-
posal / Environmental Protection").
- Do not use petrol/oil mixtures;
- Use normal or super unleaded
petrol;
- Only use clean, fresh petrol;
- Do not store petrol for longer
than one month, as its quality
deteriorates.
1. Unscrew the filler cap (
and pour in the petrol to the filler
plugs (30). Do not fill the tank
entirely, to allow the petrol room
to expand.
2. Wipe away petrol residues
around the filler cap and close
the filler cap.

Operation

A certain level of noise exposure
caused by this device is unavoid-
able. Rearrange noise-intensive
works to times approved and spec-
ified for this purpose. Comply with
the rest periods and reduce the
work period down to the minimum.
For your personal protection and
the protection of people near by,
suitable hearing protection must be
worn.
Starting and Stopping the
Engine
Warning! Petrol is flammable.
Start the engine at least 3 m
away from the filling location.
There is a risk of fire.
88
Start the equipment on a sturdy,
level base, if possible not in long
grass. Ensure that the cutting tool
is touching neither objects nor the
ground.
For your safety: Stand behind the
device when starting it.
Check the petrol and oil levels
regularly (see "initial operation")
and refill in time.
3x
9)
1. Press the petrol
2. Pull the safety loop (3) towards
3. Pull the starter handle (8).
4. If the motor starts slowly, re-
For a warm start it is not neces-
sary to press the primer (31).
If the primer is pressed too often,
too much petrol will enter the car-
burettor and the motor is difficult to
start.
Motor stop:
Release the safety loop (3). The
motor switches off and the knife is
braked.
Knife stopping device:
Regularly examine the knife stopping
device: Release the safety loop (3). The
motor switches off and the knife is braked.
The knife must stop within 7 seconds.
RUN
STOP
START
Cold start:
pump (31)(primer) 3 x.
the grip handle (1) and hold it.
lease the starter handle into the
starter rope-guide (4).

Publicidad

Tabla de contenido
loading

Tabla de contenido