Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
GB
We recommend contacting an au-
thorised Briggs & Stratton dealer
for maintenance work on the en-
gine.
You can find a dealer near you
here: www.briggsandstratton.com
Cleaning and General
Maintenance Work
Tilt the device back for cleaning
and maintenance jobs at the bot-
tom side so that the spark plug
faces upwards.
Make sure that a second person
holds the device because there is
a danger of tipping backwards.
Do not tilt the equipment sideways
or forwards. Operating fluids could
leak out and the engine could be
damaged.
•
Always keep the equipment clean. To
clean, use a toothbrush or cloth but no
corrosive cleaning agents or solvents.
Do not use water to clean the engine
as it could contaminate the fuel sys-
tem.
•
To clean the blade housing, it is possi-
ble to connection a hose to the upper
side of the housing (
(see
27).
•
After mowing, remove plant remains
that are stuck to the equipment by us-
ing a piece of wood or plastic. Clean
the vent holes (
and blade area especially. Do not use
hard or pointed objects, which could
damage the equipment.
•
Oil the wheels from time to time.
•
Before each use, check the lawnmow-
er for obvious defects such as loose,
worn or damaged parts. Check that
100
16)
7), ejection hole
all nuts bolts and screws are sitting
firmly.
•
Check covers and guards (
13, 21) for damage and that they are
sitting correctly. Replace if necessary.
Cleaning/Replacing the
Air Filter
Do not operate the equipment
without the air filter otherwise dust
and dirt will get into the engine and
result in damage to the machine.
1. Remove the spark plugs connector (
11) (see "Maintaining the Spark
Plug").
2. Open the air filter box (9) and take out
the air filter (10).
3. Clean the air filter (10) with soap solu-
tion and let it dry. Put a few drops of
fresh engine oil into the air filter.
4. To install, place the air filter (10) in the
air filter box (9) and reclose it.
Maintaining the
Spark Plug
A worn spark plug or a spark gap
that is too large will result in a re-
duction of engine performance.
1. Disconnect the spark plug connector
(11) from the spark plug (12) by simul-
taneously pulling and turning.
2. Unscrew the spark plug (12) anti-
clockwise.
3. Check the spark gap using a feeler
gauge (available from specialist
shops). The spark gap must be at
least 0.5-0.6 mm.
4. If necessary, adjust the gap by care-
fully bending the ground electrode on
the spark plug.
2, 7,
Publicidad
Capítulos
Tabla de contenido
