Led Indicator - ausdom AH2 Manual De Instrucciones

8. Using the Headphone
The table below shows you how to use the button on your
headphone.
Action
Power On
Power Off
Pairing Mode
Play Music
Pause Music
Adjust Volume
Adjust Music Track
Answer a Call
End a Call
Reject a Call
Transfer a Call
Use Last No. (Redial)
Cancel Dialing

9. LED Indicator

The LED Indicator specifies the status of your headphone. The
table below shows you the various LED indications available.
Description
Press and hold the power button for 2 seconds to
power on the headphone. The LED indicator flashes
blue 1 time and sounds a short music indicating
the headphone has been powered on already.
Press and hold the power button for 4 seconds to
power off the headphone. The LED indicator flashes
red 1 time and sounds a short music indicating
the headphone has been powered off already.
Press and hold the power button on the headphone until
it powers on but don't let go just yet. Continue holding
down on the power button until you see the LED
indicator flashes blue and red alternately, which means
your headphone is in"pairing mode"waiting to be paired
with your device.
Press the power button once to continue playing
music when the music is paused.
Press the power button once to stop the music
playback.
Press the + or - button to adjust the volume.
Press and hold the + or - button to select the
music track.
Press the power button or use your mobile phone to
answer a call.
Press the power button or use your mobile phone to
end the call.
Press and hold the power button for 2 seconds.
Press and hold the power button for 2 seconds to
switch the call between the mobile phone and
headphone.
Press the power button twice quickly.
Press the power button to cancel dialing.
EN-5