- before taking out the products, wait until the cutter stops, then press the lock buttons (5) and
disconnect the body (4) from the lid (14),
- unlock the lid (14) by turning it to the left and remove,
- remove the cutter (16) by grabbing its upper part and then pull out the products.
DISC WITH REPLACABLE FACES
using a disc with replaceable faces, it is possible to cut and slice, e.g. cucumbers, onions,
mushrooms, apples, carrots, radishes, raw potatoes, zucchini, cabbage, potatoes, etc.
- peel and cut the products into pieces sized to the opening in the lid (14),
- install one of the replaceable faces (18, 19, 20, 21) in the disk (17),
- place the disc (17) with the mounted face in the container (15),
- place the lid (14) on the container (15) according to the markings and lock it by turning it to the left,
- fix the body (4) in the lid (15) - make sure it is properly seated,
- select the appropriate speed using the controller (1) and press the button (2 or 3). use high
revolutions to grind hard ingredients,
- place the prepared products in batches in the dispensing tunnel located in the lid (14) and use the
pusher (13) to slide it downward into the rotating disc,
- in the case of thin products (e.g. carrots), the tunnel hole can be reduced by pulling its middle part
from the pusher (13).
Never put your fingers or any objects into the dispensing tunnel.
Do not exert too much pressure on the pusher, as this may damage the appliance.
- before taking out the products, wait until the disc stops, then press the lock buttons (5) and
disconnect the body (4) from the lid (14),
- unlock the lid (14) by turning it to the left and remove,
- remove the disc (17) by grabbing its upper part and then pull out the products.
CLEANING AND MAINTENANCE
Disconnect the unit from the mains before cleaning.
No components are suitable for washing in dishwashers.
Do not immerse in water.
Do not clean the appliance with sharp, abrasive cloths or sponges as you can
damage the appliance this way.
- the crusher (6) and the whisk adapter (7) and the lid (9, 14) must not be completely immersed in
water. Complete immersion of the elements (6, 7, 9, 14) in water may damage them and void
the warranty.
- the crusher (6) and the whisk (8) with the adapter (7) should be detached from the body (4) for
cleaning. Clean them with water and some washing-up liquid. Only the cutter tip and the whisk tip
can be immersed,
- the body (4) can be wiped with a damp cloth,
- other components can be washed in warm water with some washing-up liquid and rinsed under
running water,
- containers (11, 12, 15) are not suitable for washing in the dishwasher and for storing products in
the refrigerator.
Cutters (10, 16), crusher cutter (6) and replaceable disc faces (18, 19, 20, 21) must not be
cleaned with bare hands. Use a small brush for cleaning.
•
12
EN