Sony SDM-X52 Manual De Instrucciones página 21

Symptom
Picture is fuzzy.
Picture is ghosting.
Picture is not centered or sized
properly (analog RGB signal only).
Picture is too small.
Picture is dark.
Wavy or elliptical pattern (moire)
is visible.
Color is not uniform.
White does not look white.
Monitor buttons do not operate
( appears on the screen).
The monitor turns off after a while. • Set the power saving function to OFF (page 16).
Displaying this monitor's name, serial number,
and date of manufacture.
While the monitor is receiving a video signal, press and
hold the MENU button for more than 5 seconds.
The monitor's information box appears. Press the MENU button
again to make the box disappear.
Example
INFORMATION
MENU
MODEL : SDM-X82
SER. NO : 1234567
MANUFACTURED : 2002-40
Check these items
• Adjust the brightness and contrast (page 12).
• Adjust the pitch and phase (analog RGB signal only) (page 13).
xProblem caused by a connected computer or other equipment, and not
caused by the monitor
• Set the resolution to 1024 × 768 (SDM-X52), 1280 × 1024 (SDM-X72/X82) on your
computer.
• Eliminate the use of video cable extensions and/or video switch boxes.
• Check that all plugs are firmly seated in their sockets.
• Adjust the pitch and phase (page 13).
• Adjust the picture position (page 14). Note that some video modes do not fill the screen to
the edges.
• Set the zoom setting to FULL2 (page 15).
xProblem caused by a connected computer or other equipment, and not
caused by the monitor
• Set the resolution to 1024 × 768 (SDM-X52), 1280 × 1024 (SDM-X72/X82) on your computer.
• Adjust the brightness (page 12).
• Adjust the backlight (page 12).
• It takes a few minutes for the display to become bright after turning on the monitor.
• Adjust (GAMMA) (page 15).
• If you press the ECO button, the screen turns darker.
• Adjust the pitch and phase (analog RGB signal only) (page 13).
• Adjust the pitch and phase (analog RGB signal only) (page 13).
• Adjust the color temperature (page 14).
• If the menu lock is set to ON, set it to OFF (page 16).
xProblem caused by a connected computer or other equipment, and not
caused by the monitor
• Set the computer's power saving setting to off.
If any problem persists, call your authorized Sony dealer and give
the following information:
• Model name: SDM-X52, SDM-X72, SDM-X82
• Serial number
• Name and specifications of your computer and graphics board.
• Type of input signals (analog RGB/digital RGB)
Model
name
Serial
number
Week and
year of man-
ufacture
GB
21