Chattannoga OptiFlex SHOULDER CPM Modo De Empleo página 26

5.4.3 Isolated elevation
(flexion)
1. First adjust an angle of 90° for
external rotation and deactivate
motor B as follows:
a. Press the MENU key on the
programming unit to access level 1
(M1).
b. Press the parameter key for
external rotation
the carriage to the rotation position
of 90°, using the + / - keys.
Note!
- For an exclusive elevation protocol,
motor B for the rotation movement
must be turned off as described in
steps c to e below.
- Having programmed the ranges of
motion, you can program additional
options, such as pause or speed.
c. Press the MENU key on the
programming unit to access level
3 (M3).
d. Press the Motor B ON/OFF
parameter key to activate
the parameter.
e. Deactivate motor B by pressing
the parameter key Motor B
ON/OFF again or the "–" (minus)
key. The check mark in the circle
next to the symbol must have
disappeared.
f. Save the entered values by press
the STOP key.
2. Complete the mechanical settings
and adjust the carriage to the patient
as follows:
a. Adjust an angle of 90° for horizon-
tal adduction/abduction
indexing knob (12).
b. Secure and hold the motion
element at the holding tube for
length adjustment and open the
locking screw (14) for height
c. Now open clamping lever (18) for
and move
d. Open clamping lever (26), adjust
3. In the next step, program the eleva-
tion range of motion as follows:
a. Press the MENU key on the
b. Next set the desired range of
c. Set the abduction
Note!
Having programmed the ranges of
motion, you can program additional
options, such as pause or speed.
4. Save the settings with the STOP key,
set the carriage to the starting
position with the START key and
initiate therapy by pressing the
START key again.
†
, using
26
Œ
adjustment . Select a height at
which the pivot points of motor A
and the shoulder are at the same
level.
adjustment of the upper arm
Å
length , locking screw (20) for
adjustment of the elbow angle
and locking screw (28) for adjust-
ment of the forearm rest inclina-
tion and set the motion element to
a position that is comfortable to
the patient and suitable for the
therapy session . When done,
tighten all screws and levers.
ì
the forearm length
patient and close the clamping
lever.
programming unit to access level
1 (M1).
motion for adduction and abduc-
tion by first pressing the parame-
ter key for adduction
set the values with the +/- keys.
the same way.
è
to the
and
value in