Chattannoga OptiFlex SHOULDER CPM Modo De Empleo página 29

9.Only use the original shipping box for
transporting the device. Chattanooga
cannot be held liable for transport
damage, if the device was not
shipped in its original shipping box.
10. Place the OptiFlex ®
on the bottom of the box. The
markings on the bottom of the box
indicate the correct position.
11. Then put the enclosed polystyrene
block on the chair, observing the
cut-outs in the block.
12. Put the programming unit (1) in the
supplied box. Place the motion
element, the armrest, the compo-
nents of the neck restraint and the
power cord in the respective cut-
outs in the polystyrene block.
S – legs down –
29
13. Then close the box.
Reverse the above steps to reassemble
the device after transport.
Warning!
Shock hazard – Before use allow the
OptiFlex ® S to reach room tempera-
ture. If the device has been transpor-
ted at temperatures below 0 °C (32
°F), leave it to dry at room tempera-
ture for about 2 hours, until any
condensation has disappeared.