Conversion - Chattannoga OptiFlex SHOULDER CPM Modo De Empleo

6.4 Conversion

The OptiFlex ® S can be used on the left
and on the right shoulder joint. How-
ever, the device must be converted first.
This is done very quickly.
1. Activate the "transport setting"
function in the menu (see
also 5.3) and start the OptiFlex
2. On both sides adjust an angle of 90°
for horizontal adduction/abduction
(indexing knob 12) (see conversion
drawing † ).
3. Open locking screw (14), remove the
armrest for the healthy arm and
place it on the seat (see conversion
diagram † a).
4. Grasping the holding tube (17) of the
motion element, open locking screw
(14).
5. Remove the motion element and
insert it on the opposite side.
Tighten locking screw (14) (see
conversion diagram † b, c).
Conversion diagram:
6. Open locking screw (20) and rotate
the forearm rest 180°.
Tighten locking screw (20) (see
conversion diagram Πd).
7. Hold the forearm rest and open
locking screw (28).
8. Swivel the forearm rest to the other
side around motor B and tighten
locking screw (28) (see conversion
diagram Å e).
® S.
9. Insert the armrest for the healthy
arm into the holding tube and
tighten locking screw (14).
10. Set horizontal adduction/abduction
to the desired value on the side of
the motion element (normally a value
between 0° and 40°, as needed).
30