Hitch Handle Assembly - Husky 31313 Instrucciones De Montaje, Instalación, Funcionamiento Y Mantenimiento

Hitch Handle Assembly

a. Place the hitch head onto the adjustable cross member and secure with the supplied 3/8" clevis pins and hair
pins. Check for freedom of movement.
b. Rotate the handle shaft while pulling it straight out, once the shaft starts sliding out of the guide tube pull it
all the way out to lock the hitch head in the open position.
HANDLE SHAFT
GUIDE TUBE
c. Hold the handle with the grip pointed upward and slide the handle onto the handle shaft.
d. Fasten the hitch handle using the supplied ¼-20 HEX HEAD BOLT and ¼-20 NYLON LOCK NUT.
Tighten lock nut until it comes in contact with the tube.
e. Use a wrench to trip the lock mechanism to close the hitch head. Be careful to keep your body away
from any moving parts. The handle should rotate and point down towards the bed of the pickup truck.
All Products limited to Vehicle Tow Rating; see Vehicle Owners Manual. See
Warranty Information / Tech Support ©2014 Husky Towing Products June 3, 2014-REV 4
7 of 61
Trip lock mechanism
www.huskytow.com for