INFORMATION FOR USERS
- To insure an adequate protection, this helmet must fit closely and be securely attached.
- Any helmet that has sustained a violent impact should be replaced.
- Warning! Do not apply paint, stickers, petrol or other solvents to this helmet. Use only warm soapy water
to clean the helmet surface.
ECE 22.05
MISE EN GARDE
- Pour assurer une protection suffisante, ce casque doit être bien ajusté et être solidement attaché.
- Tout casque qui a été soumis à un choc violent est à remplacer.
- Attention : N'appliquer sur ce casque ni peinture, ni autocollant, ni essence, ni aucun autre solvant.
N'utilisez que de l'eau chaude et savonneuse pour nettoyer le casque.
ECE 22.05
WAARSCHUWING
- Om een voldoende bescherming te waarborgen moet deze helm goed passen en tevens een goed zijdelings
zicht mogelijk maken.
- Iedere helm die een hevige klap heeft opgevangen dient te worden vervangen, zelfs al is de geleden schade
op het eerste zicht niet merkbaar.
- Niet verven, noch reinigen met bijtende producten. Gebruik warm water en zeep voor het reinigen van de helm.
ECE 22.05
WARNUNG
- Um einen ausreichenden Schutz zu ermöglichen muss dieser Helm genau passen und außerdem eine gute
seitliche Sicht garantieren.
- Jeder Helm, der einem heftigen Stoss ausgesetzt wurde, ist unbedingt zu ersetzen, auch wenn der Helm
unbeschädigt scheint und keine sichtbaren Schäden aufweist. Der Helm darf weder mit Farbe bestrichen
noch mit Beizmitteln gereinigt werden.
ECE 22.05
AVISO
- Para garantizar una protección suficiente, su casco tiene que estar bien ajustado y tiene que asegurar al
mismo tiempo una buena visión lateral.
- Cada casco que haya sido expuesto a un golpe violento tiene que substituirse por otro.
- Atención ! no se puede aplicar pintura, pegatinas, gasolina o productos agresivos en el casco. Use agua
caliente y jabón para limpiar la superficie del casco
ECE 22.05
AVISO
- Para garantir a proteção adequada, este capacete tem que estar bem ajustado e com boa visão lateral.
- Todo capacete que tenha sofrido qualquer tipo de impacto deve ser trocado.
- Atenção! Não aplique pinturas, adesivos, derivados de petróleo ou qualquer tipo de solvente neste capacete.
Use somente água morna com sabão neutro para limpar a superfície do mesmo.
ECE 22.05
ATTENZIONE
- Per garantire una protezione sufficiente, questo casco deve essere ben calzato sulla testa e saldamente
allacciato.
- Il casco che ha subito un urto violento deve essere sostituito.
- Attenzione! Non utilizzare vernici, benzina o altri prodotti chimici. Non applicare adesivi. Pulire il casco
esclusivamente con un panno morbido umido e sapone neutro.
ECE - R22.05
WARNING
No helmet can protect the wearer against all possible impacts.
For maximum protection the helmet must fit firmly on the head, and the reten-
tion system must be securely fastened. With the retention system comfortably
but firmly adjusted, it should not be possible for the helmet to be removed from
the head when pulled at the rear in an upward and forward direction.
Ensure that any visor attached to the helmet meets the requirements of AS 1609.
The helmet is unsuitable for use with goggles.
The helmet is unsuitable for use with communications devices. (if suitable for use
with communications devices, list the appropriate devices.)
No attachments should be made to the helmet except those recommended by the
helmet manufacturer. Do not drill or cut the shell.
The helmet is designed to absorb shock by partial destruction of the shell and
liner. This damage may not be visible. Therefore if subjected to a severe blow, the
helmet should be replaced even if it is apparently undamaged.
The liner is essential to the intended performance of the helmet.
The helmet has a limited lifespan in use and should be replaced when it shows
obvious signs of wear, e.g. change of fit, cracks, rust or fraying.
THE PROTECTION OF THIS HELMET MAY BE SEVERELY REDUCED BY THE APPLICATION
OF PAINT, ADHESIVE STICKERS OR TRANSFERS, CLEANING FLUIDS OR OTHER SOLVENTS.
USE ONLY MATERIALS RECOMMENDED BY THE HELMET MANUFACTURER.
AS-NZS 1698: 2006