NEOiD PTZ NDI 20X Manual Del Operador página 98

Baud rate: 2400/4800/9600/38400
Starting Position: 1 bit
Data bits: 8 bits
Stop bits: 1 bit
Parity: None
RS485 Communication Control
Control camera via RS485, half duplex mode:
Baud rate: 2400/4800/9600/38400
Starting Position: 1 bit
Data bits: 8 bits
Stop bits: 1 bit
Parity: None
After power on, the camera goes to the upper right limit and then back
to the middle position. The zoom lens is pulled to the farthest position,
auto focus, and the aperture is adjusted to the default value. If the
camera has preset 0 saved, the camera will be set to position 0 after the
initialization is completed. At this point, the user can use the serial port
command to control the camera.
List of protocols (omitted)
The serial port of the camera follows the VISCA/Pelco-D/Pelco-P
standard protocol. If secondary development is required, the camera can
be controlled according to the standard protocol.
For a detailed list of VISCA/Pelco-D/Pelco-P protocols, contact the
manufacturer.