Explanation Of Technical Specifications; Cooling Unit - Cebora Sound MIG 3840/T Manual De Instrucciones

BL
BJ
BA
BB
BI
BO
Art 389
BP
BQ
BG - Opening :
Slot for cooling hoses
BH - Quick-fitting sockets :
Connect the red and blue tubes of the wire feeder/ power
source connection. NOTE: Match the hose and socket
colours correctly
BI - Quick-fitting sockets:
Connect any hoses leaving a water-cooled torch.
NOTE: Match the hose and socket colours correctly
BJ - Door.
BL - Wire coil cover.
BM - Coil support:
Suitable for standard coils up to Æ 300 mm, 16 Kg.
BN - Adjustment knob:
Use this knob to adjust the pressure of the wire feeder
rollers on the welding electrode. NOTE: set to minimum
values when welding aluminum.

2.3 COOLING UNIT

This cooling unit has been designed to cool the torches
BD
BE
BF
BC
BG
BH
BU
BV
BS
BO
BR
BT
BW
BX
Fig. 1
used for TIG and MIG/MAG welding.
Must be used exclusively with this power source.

2.3.1 Explanation of technical specifications

U1 Rated supply voltage
1x400V (230V) Single-phase power supply
50/60 Hz Frequency
I1max Maximum absorbed current
Pmax Maximum pressure
P (1l/min) Refrigerant power measured at 1L/min
2.3.2 DESCRIPTION OF PROTECTIONS
2.3.2.1 Coolant pressure protection
This protection is achieved by means of a pressure
switch, inserted in the fluid delivery circuit, which controls
a microswitch.
2.3.2.2 Fuse (T 1.6A/400V-Æ 6.3x32)-(for Art.389 only)
This fuse was inserted to protect the pump, and is locat-
ed on the control circuit inside the unit. The message
BM
BZ
BY
15