General Descriptions; Description Of The Machine; Explanation Of Technical Specifications - Cebora bravo 165 combi Manual De Instrucciones

INSTRUCTION MANUAL FOR WIRE WELDING MACHINES
IMPORTANT:
READ THIS MANUAL CAREFULLY BEFORE INSTALL-
ING, USING, OR SERVICING THE WELDING MACHINE,
PAYING SPECIAL ATTENTION TO SAFETY RULES.
CONTACT YOUR DISTRIBUTOR IF YOU DO NOT FULLY
UNDERSTAND THESE INSTRUCTIONS.
1 INSTALLATION
This machine must be used for welding only. It must not be
used to defrost pipes.
It is also essential to pay special attention to the chapter on
SAFETY PRECAUTIONS.
The symbols next to certain paragraphs indicate points
requiring extra attention, practical advice or simple informa-
tion.
This manual must be stored carefully in a place familiar to
everyone involved in using the machine. It must be con-
sulted whenever doubts arise and be kept for the entire life-
span of the machine; it will also be used for ordering
replacement parts.
1.1 PLACEMENT
Unpack the machine and place it in an adequately ventilated
area, dust-free if possible, taking care not to block the air
intake and outlet from the cooling slots.
CAUTION: REDUCED AIR CIRCULATION causes over-
heating and could damage internal parts.
Keep at least 500 mm of free space around the machine.
Never place any filtering device over the air intake points of
this welding machine.
The warranty shall become void if any type of filtering device
is used.
Mount the parts supplied with the machine as shown in the
figure 1.
2

DESCRIPTION OF THE MACHINE

A) Switch.
Switches the machine on or off.
8 8 8
Fig. 1
B) Adjustment knob.
This knob varies the welding wire feed speed
C) Central connector.
For connecting the welding torch
D) Ground connector.
Connector for the machine ground terminal
E) Selector switch.
Sets welding voltage. In some versions it switches the
machine on or off.
F) Adjustment knob.
This knob sets spot welding time.
Press the torch pushbutton to start welding.
Spot welding time is controlled by the knob.
To restart the cycle, release the torch pushbutton and
then press it again.
G) Led (green).
This Led indicates that the machine is on.
H) Led (yellow).
This Led lights up if the thermostat trips and stops the
welding machine.
3

GENERAL DESCRIPTIONS

3.1 SPECIFICATIONS
This welding machine allows welding of mild steel, stainless
steel and aluminium.
3.2

EXPLANATION OF TECHNICAL SPECIFICATIONS

EN60974.1 The welding machine is built according to these
international standards.
N° Serial number, which must always be indicated in
any inquiry regarding the welding machine.
Fig. 2