Dremel 8260 Instrucciones De Funcionamiento Y Seguridad página 17

charts enable you to select both the
correct acces sory and the optimum
speed at a glance.
Increasing the pressure on the tool is
not the answer when it is not
performing as you think it should.
Perhaps you should be using a different
accessory, and perhaps an adjustment
in speed would solve the problem.
Leaning on the tool does not help.
Let speed do the work!
All Dremel Rotary Tool attachments are
compatible with your tool, but you may
experience reduced run times on the
battery when using certain attachments.
Learn the LED Behavior
If you turn off the tool with the battery
still inserted, the tool LEDs will behave
as follows:
- The Speed
illuminated for 5 minutes to show the
last set speed setting.
- The Warning and Battery Gauge LEDs
will remain illuminated for 30
seconds.
To turn off all LEDs, remove the
battery pack after the tool has been
turned off.
Managing Speed Settings
- You can preselect a speed between
5,000 – 30,000 RPM on the Dremel
App.
- Once you have chosen your desired
speed on the app, the corresponding
speed will blink for 10 seconds on
the speed indicator 11 on the tool
(Fig. 7).
- To confirm the app set speed, you
must turn on the tool within 10
seconds.
- If turned on within 5 minutes, the
tool will turn on at its last set speed
setting.
- If turned on after 5 minutes, the tool
will turn on at its default speed
setting of 15,000 RPM.
Learn the LED Behavior
If you turn off the tool with the battery
still connected the tool LEDs will behave
Operating Instructions
LED will remain
as follows:
- The Bluetooth LED will remain
illuminated for 5 minutes as long as
your tool is still connected to your
smart device.
- The Speed
illuminated for 5 minutes to show the
last set speed setting.
- The Warning, Battery Gauge, and
Dremel Logo LEDs will remain
illuminated for 30 seconds.
To turn off all LEDs, turn off the tool
and remove the battery pack.
Red Warning LED
The red warning LED 9 will illuminate
for one of the following reasons:
- Excessive tool temperature: turn the
tool off and remove the accessory
(Be careful – the accessory may be
hot). Then turn the tool on and
allow it to run without load so the
motor's fan can help cool down the
tool.
- Excessive battery temperature: turn
the tool off, remove the battery
pack and allow the battery to return
to normal operating temperature
before resuming use.
- Tool stall / overload warning: too
much pressure is being applied to
the tool. Reduce pressure to hold
and guide the tool. Allow the speed
of the tool to do the work.
Bluetooth LED
- The Bluetooth LED 10 indicates the
tool is connected to the smart device
(Fig.7).
- The Bluetooth LED will repeatedly
blink on the tool as it attempts to
connect to the smart device.
- Confirm connection of the tool to
the smart device by turning the
variable speed dial 8 in either
direction (Fig. 7).
- After completing this process you
should see the connected tool in the
App and the Bluetooth LED will be
illuminated on the tool and will no
longer be blinking.
17
LED will remain