Operation; Energy Saving Tips - Waeco CoolMatic CB-36 Instrucciones De Uso

Frigorífco empotrabe por compresor
Ocultar thumbs Ver también para CoolMatic CB-36:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 51
CB-36, CB-40, CB-110, RHD-50
Connecting to 230 V mains supply
Danger of fatal injuries!
a
Never handle plugs and switches with wet hands or if you are
standing in a puddle.
Caution!
e
If you are operating your cooling device on board a boat with a
mains connection of 230 V from the land, you must install a ground
protection circuit breaker between the 230 V mains supply and the
cooling device.
Seek advice from a trained technician.
➤ To operate the cooler on a 230 V or 110–240 V mains supply, use the
EPS-100W (230 V) or MPS-35 (110 – 240 V) rectifier.
7

Operation

Note
I
Before starting your new cooling device for the first time, you
should clean it inside and outside with a damp cloth for hygienic
reasons (please also refer to the chapter "Cleaning and mainte-
nance" on page 30).
7.1

Energy saving tips

Choose a well ventilated installation location which is protected against di-
rect sunlight.
Allow food to cool down first before placing it in the device.
Do not open the cooling device more often than necessary.
Do not leave the door or lid open for longer than necessary.
Defrost the cooling device as soon as a layer of ice forms.
Avoid unnecessarily low temperatures.
Clean the condenser of dust impurities at regular intervals.
Clean the lid seal regularly.
Operation
27

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Coolmatic cb-40Coolmatic cb-110Coolmatic rhd-50

Tabla de contenido