Release And Remove The Suction Head; Pull Over The Safety Filter Sack; Pull Out The Safety Sheet; Close The Safety Filter Sack Using The - Kärcher NT 75/1 Tact Me Te H Manual Original

Dry vacuum cleaning
The appliance is equipped with a paper
–
filter bag fitted with locking lid.
Order No. Safety filter sack: 6.904-
420.0 (5 pieces)
Note: You can use this appliance to take up
all types of dust up to dust class H. It is stat-
utorily necessary to use a dust collection
bag (see Filter systems for order number).
Note: The appliance is suited as industrial
vacuum cleaner and as dedusting device
for the mobile operation to take up dry, non-
combustible dusts with MAK values.
Unused flat-fold filters may only be
–
stored and transported in the packaging
(carton).
Illustration
The lamella of the flat-fold filter should
–
not be touched during installation.
Warning
The flat-fold filter and the safety filter sack
must never be removed during the dust ex-
traction process.
Installing the safety filter sack
 Release and remove the suction head.
Illustration
 Insert the safety filter sack.
Illustration
 Place the safety filter bag over the con-

tainer and insert the interior paper filter

bag into the container in an L-shaped

fashion.
 Insert and lock the suction head.
Wet vacuum cleaning
Danger
No dusts hazardous to health should be
sucked in during wet vacuuming.
Inserting the rubber lips
Illustration
 Remove the brush strips.
 Install the rubber lips.
Note: The structured side of the rubber lips
must point outwards.
Close the suction connection
Illustration
 Properly insert the connection socket in
the suction connection.
 Push in the connection socket until it
locks into place.
 Turn the suction connection with the
connection socket to the right to close it
tightly.
Note: The accurate fit is ensured by means
of a "bayonet connection".
Removing the safety filter sack
 Release and remove the suction head.
Illustration
 Pull over the safety filter sack.
Illustration
 Pull out the safety sheet.
 Close the safety filter sack using the

self-adhesive flap.

 Pull the safety filter bag down and back-

wards from the filter nozzle.

Illustration
 Close tightly the opening of the suction

connection of the safety filter sack using

the closing lid.

Illustration
 Securely close the safety filter bag with

the attached cable tie.

 Remove the safety filter bag.
 Wipe the inside of the container using a

damp cloth.

 Dispose of the safety filter bag in a dust-

tight bag according to the statutory pro-

visions.
 Insert and lock the suction head.
To suck wet dirt, always remove the
–
safety filter bag.
EN
– 4
21