Troubleshooting Guide - Kenwood KHC29 Instrucciones

O Never use a wire brush, steel wool or
bleach to clean your stainless steel bowl.
Use vinegar to remove limescale.
O Keep away from heat (cooker tops, ovens,
microwaves).
O
Service and Customer Care
If you experience any problems with the
operation of your appliance, before
requesting assistance refer to the
'Troubleshooting Guide' section in the
manual or visit www.kenwoodworld.com.
O
Please note that your product is covered by a
warranty, which complies with all legal
provisions concerning any existing warranty
and consumer rights in the country where the
product was purchased.
If your Kenwood product malfunctions
O
or you find any defects, please send it or bring
it to an authorised KENWOOD Service Centre.
To find up to date details of your nearest
authorised KENWOOD Service centre visit
www.kenwoodworld.com or the website
specific to your Country.

Troubleshooting Guide

Problem
Appliance stopped during
operation.
Cause
No Power.
Machine overloaded/ maximum
capacities exceeded.
Outlet covers not fitted or
unlocked.
Cleaning Instructions - Refer to the
cleaning chart on the inside of the
back cover.
O
Designed and engineered by Kenwood in the
UK.
O
Made in China.
IMPORTANT INFORMATION FOR
CORRECT DISPOSAL OF THE PRODUCT
IN ACCORDANCE WITH THE EUROPEAN
DIRECTIVE ON WASTE ELECTRICAL AND
ELECTRONIC EQUIPMENT (WEEE)
At the end of its working life, the product must not
be disposed of as urban waste. It must be taken to a
special local authority differentiated waste collection
centre or to a dealer providing this service.
Solution
Check appliance is plugged in. Turn the
speed switch to the off position, wait a few
seconds and then re-select the speed. The
appliance should resume operating straight
away.
Check maximum capacities in the
'Recommended Usage Chart'.
Check that the outlet cover/s are fitted
correctly.
6